Maxtor 777 W V1.0 Manual de instrucciones descargar pdf (Pagina 41)

8921ADT Instruction Manual 41

Conﬁguration

To load a saved ﬁle from a location outside of the frame:

1. Select the Load from ... button under File Operations in the Current or

E-MEM row.

This will bring up the Load Current Conﬁg page (Figure 18) or the Load

E-MEM page (not shown).

2. Browse to the location of the ﬁle you wish to load and select the ﬁle.

Select the

Open button to load the ﬁle or enter the ﬁlename and path in

the Enter ﬁlename box.

3. Once the correct path and ﬁlename is loaded, select the Load button on

the Load Current Conﬁg or Load E-MEM page.

4. This will place the recalled conﬁguration from the ﬁle into the module.

The

Last Recalled E-MEM ﬁeld will report File.

Figure 18. Load Current Conﬁg Page

Recall Defaults

Default settings for the module can be recalled by selecting the Recall

Defaults

button on the main E-MEM page. The defaults will revert to the set-

tings given in the Default column in Table 4 on page 22. The

Last Recalled

E-MEM

ﬁeld will report Default.

Note Default settings for Sample Rate, AES Output Resolution, and Output Pro-

cessing Mode will match the hardware jumper settings made in Module

On-board Jumper Settings on page 8 during installation. Default settings for

the AES 1 and AES 2 output processing modes will match the setting on the

AES 1 and AES 2 rotary switches on the front of the module.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 57 58

Sin comentarios

Maxtor 777 W V1.0 Manual de instrucciones Pagina 41