
8921ADT Instruction Manual 27
Configuration
Set Output Processing Modes
Two rotary switches are provided on the front edge of the module for
setting the desired output mode for AES 1 (SW1) and AES 2 (SW2). Refer to
Output Processing Modes on page 18 for an overview of each mode.
Bank 2 (BANK 2 LED on)
Bank 2 (BANK 2 LED on)
0– –Default position for normal operation (paddle has no effect).
1 Increase Decrease Adjust output gain of both Ch A and Ch B of AES 1 together.
1
2 Increase Decrease Adjust output gain of both Ch C and Ch D of AES 2 together.
1
3 Increase Decrease Adjust output gain of Ch A of AES 1.
4 Increase Decrease Adjust output gain of Ch B of AES 1.
5 Increase Decrease Adjust output gain of Ch C of AES 2.
6 Increase Decrease Adjust output gain of Ch D of AES 2.
7 Increase Decrease Delay Ch A output of AES 1 separately.
8 Increase Decrease Delay Ch B output of AES 1 separately.
9 Increase Decrease Delay Ch C output of AES 2 separately
A Increase Decrease Delay Ch D output of AES 2 separately.
B Increase Decrease Delay both channels of AES 1 output together.
C Increase Decrease Delay both channels of AES 2 output together.
D-E – – Not used.
F Recall – Recall defaults as given in Bank 1, position F.
1
Preserves gain offsets between channels.
Table 6. AES 1 and AES Modes Switch Settings
Position AES 1 Processing Mode AES 2 Processing Mode
0 A, B (Pass) C, D (Pass)
1– A, – B – C, – D
2– A, B – C, D
3 A, – B C, – D
4A + B (– 6 dB) C + D (– 6 dB)
5A + B, A–B (MS D/E) C + D, C–D (MS D/E)
6– (A + B) – (C + D)
71 kHz 1 kHz
8 400 Hz 400 Hz
9 Silence Silence
AA + B, C C, D (Pass)
BA + B, D C, D (Pass)
C-D A, B Pass C, D (Pass)
E A/B ID C/D ID
F A, B (Pass) C, D (Pass)
Table 5. CONTROL Rotary and Paddle Switch Functions
Rotary
Switch
Setting
Paddle
Switch Up
Paddle
Switch Down
Function Description
Comentarios a estos manuales