Maxtor 777 W V1.0 Manual de instrucciones descargar pdf (Pagina 38)

38 8921ADT Instruction Manual

Conﬁguration

Audio Proc Page

The Audio Proc page (Figure 15) reports the following for each AES output

channel:

•Presence of audio input signal (True = > – 40 dBFS)

•Clip status of audio input signal (True = > – 0.5 dBFS)

Use the Audio Proc page to make the following adjustments:

•Processing – set the output processing mode for AES 1 and AES 2 from

the corresponding Processing pulldown. Refer to Output Processing

Modes on page 18 for an overview of each output processing mode.

Note Also set the on-board AES1 and AES2 Mode rotary switches on the front of

the module to match your settings. Refer to Set Output Processing Modes on

page 27. If defaults are recalled, the module will default to the local settings.

•AES Output Resolution – set the output resolution to 20 or 24 bit for

AES 1 and AES 2. This setting will override the on-board settings made

at jumpers J13 and J14 (Table 1 on page 8 and Figure 1 on page 9).

•Gain – adjust the output gain in dB for each channel with the corre-

sponding

Gain controls.

Output gains can also be adjusted in pairs (AES 1 A and B, AES 2 C and

D) by selecting the corresponding

Locked checkbox in the Gain Locking

area and adjusting either

Gain control in the pair.

•Output Sample Rate – the default output sample rate for AES 1 and

AES 2 of

48kHz will be reported (read only).

Figure 15. 8921ADT Audio Proc Page

Use

this

link

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 57 58

Sin comentarios

Maxtor 777 W V1.0 Manual de instrucciones Pagina 38