Pan/Tilt/Zoom
Pan/Tilt/Zoom interface is shown as in Figure 6-43.
Please make sure you have properly set dome address and all connections are right.
Decoder: Select the channel which is connected with a dome camera.
Protocol: select the corresponding dome protocol. (such as PELCOD)
Address: Set corresponding dome address. Default value is 1.
Please note your setup here shall comply with your dome address;
otherwise you can not control the speed dome.
Baud rate: Select the dome baud rate. Default setup is 9600.
Data bit: Default setup is 8.
Stop bit: Default setup is 1.
Parity: Default setup is none.
Figure 6-43
Comentarios a estos manuales