Figure 5-14
5.3.5.5 NTP Setup
You need to install NTP server (Such as Absolute Time Server) in your PC first.
In Windows XP, you can use command “net start w32time” to start up NTP service.
NTP setup interface is shown as in Figure 5-15.
Host IP: Input your NTP server’s IP address.
Port: This series DVR supports TCP transmission only. Default port no is 1024.
Update interval: minimum value is 15 (Unit: minute)
Time zone: select your corresponding time zone here.
Here is a sheet for your time zone setup.
Comentarios a estos manuales