
Check the box here to enable this function. The buzzer beeps
when an alarm occurs.
System can upload the alarm signal to the centre (Including alarm
centre.
When 3G network connection is OK, system can send out a
message when motion detect occurs.
If you enabled this function, System can send out an email to alert
you when an alarm occurs.
You need to check the box here to enable this function. System
begins 1-wiindow or multiple-window tour display among the
channel(s) you set to record when an alarm occurs.
Please go to chapter 5.3.9 to set tour interval and tour mode.
Here you can set PTZ movement when alarm occurs. Such as go
to preset X. See Figure 7-52.
This function is for motion detect only. Check the box here to
enable video matrix function. Right now system supports one-
channel tour function. System takes “first come and first serve”
principle to deal with the activated tour. System will process the
new tour when a new alarm occurs after previous alarm ended.
Otherwise it restores the previous output status before the alarm
activation.
7.8.3.1.2 Video Loss
The video loss interface is shown as in Figure 7-53.
After analysis video, system can generate a video loss alarm when the detected moving signal
reached the sensitivity you set here.
Please note video loss does not support anti-dither, sensitivity, region setup. For rest setups,
please refer to chapter 7.8.3.1.1 motion detect for detailed information.
Figure 7-53
7.8.3.1.3 Camera Masking
The camera masking interface is shown as in Figure 7-54.
Comentarios a estos manuales