
Ernitec EDNS V1000 series – user manual
The keys of the remote control function as the keys of the front panel of the
DVR. The only difference between the remote control and the front panel keys
is the “DVR SEL” key. The DVR Selection key is used to switch control
between each DVR.
The remote control can be used to control up to 16 DVRs. To setup the remote
control, the first thing is to assign a unique DVR Unit ID to each DVR.
Use the front panel of the DVR, and follow this path to change the DVR Unit ID,
<Main Menu> <System Setup> <RS485 Setup> <Unit ID>. Change
the DVR Unit ID to any number between 224 and 239, and exit the menu.
The ID Table is listed below for reference.
After the DVR Unit ID is changed, setup the “DVR SEL” of the remote control.
Press “DVR SEL”, and then press the Remote Control # immediately to select
the DVR. For example, assuming the DVR Unit ID is set to 225, press “DVR
SEL” and then press “2” immediately. Now, the remote control will only be able
to control the specified DVR. Press “DVR SEL”, and then press the Remote
control # to switch between DVRs.
To exit the single DVR Control mode, press “DVR SEL”, and then press “ESC”
to do so.
Comentarios a estos manuales