Maxtor MaxLine Plus II 250GB AT Manual descargar pdf (Pagina 12)

Introduction

Maxtor MaXLine Plus II 250GB AT 1-3

The typographical and naming conventions used in this manual are listed

below. Conventions that are unique to a specific table appear in the notes

that follow that table.

Typographical Conventions:

• Names of Bits: Bit names are presented in initial capitals. An

example is the Host Software Reset bit.

• Commands: Interface commands are listed in all capitals. An

example is WRITE LONG.

• Register Names: Registers are given in this manual with initial

capitals. An example is the Alternate Status Register.

• Parameters: Parameters are given as initial capitals when

spelled out, and are given as all capitals when abbreviated.

Examples are Prefetch Enable (PE), and Cache Enable (CE).

• Hexadecimal Notation: The hexadecimal notation is given in

9-point subscript form. An example is 30

• Signal Negation: A signal name that is defined as active low

is listed with a minus sign following the signal. An example is

RD–.

• Messages: A message that is sent from the drive to the host

is listed in all capitals. An example is ILLEGAL COMMAND.

Naming Conventions:

• Host: In general, the system in which the drive resides is

referred to as the host.

• Computer Voice: This refers to items you type at the

computer keyboard. These items are listed in 10-point, all

capitals, Courier font. An example is FORMAT C:/S.

1.4 REFERENCES

For additional information about the ATA interface, refer to the latest

revision of the draft standard on the internet at http://www.t13.org/

using the link under “1410D AT Attachment - 6 with Packet Interface

(ATA/ATAPI - 6).”

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 74 75

Sin comentarios

Maxtor MaxLine Plus II 250GB AT Manual Pagina 12