Maxtor QUICKVIEW 300 Manual de usuario descargar pdf (Pagina 31)

Installation

Quickview 300 80/100/120/160/200/250/300GB PATA 3-15

3.6.1.1 Connecting the Adapter Board and the Drive

Use a 40-pin cable to connect the drive to the board.

See figure 3-8 to connect the drive to the board:

1. Insert the 80-pin conductor cable into the mating connector of the adapter

board. Make sure that pin 1 of the connector matches with pin 1 on the

cable.

2. Insert the other end of the cable into the header on the drive.

When inserting this end of the cable, make sure that pin 1 of the

cable connects to pin 1 of the drive connector.

Figure 3-8 Drive Power Supply and PATA Bus Interface Cables

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 72 73

Sin comentarios

Maxtor QUICKVIEW 300 Manual de usuario Pagina 31