Maxtor SSA-0412 Manual de usuario descargar pdf (Pagina 19)

Figure 2.2. Rear Panel Connections

Figure 2.3. Sensor input / Alarm output connections

Dried Contact

4OUT

(+)

(-)

(+)

(-)

+12VDC

ALARM

SENSOR

Sensor

Adapter

SENSOR INPUT: Connect two signal lines of sensor (infrared rays sensor, heat perception sensor, magnetic

sensor) to the desired sensor number. (You can set the type-NC or NO- of sensor at “Setup” mode).

ALARM OUTPUT: Use this at 30V/300mA or less operating voltage and current. When controlling lamp and

AC operated equipment, control it using separate outside relay. During normal operation the control output

contact is maintained at “Open” status, and during control output the output contact is changed to

Close(short)” status.

NOTICE

SENSOR inputs need dried contact only. Do not input any electric signal.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 72 73

Sin comentarios

Maxtor SSA-0412 Manual de usuario Pagina 19