Maxtor 4 Channel Stand-alone DVMR Manual de usuario descargar pdf (Pagina 41)

CHAP. 6 Network Setup

Setting Screen

PTZ TYPE : If using PTZ device or camera, select the protocol your PTZ camera is using from the list of

preconfigured protocols.

Circular Monitoring Interval : This determines the speed at which the channels sequence, when the

SEQUENCE button is used from the main interface.

PTZ Baud Rate : Enter the Baud Rate of your PTZ camera.

Run in full screen mode : When checked, this will enable the program to re-adjust the interface to

completely fill your computer screen.

Set Path to Save Recorded Image : Determines the location and folder on your PC where the saved

video clips are stored. If you do not specify a valid location, then the

program will save all files in the default location of

C:\Program Files\DvrRemoteViewer4

Name(LABEL) : This just identifies your settings. The settings are automatically saved under this label

when you hit ‘OK’.

IP Address : Based on your network scenario and from where you’re accessing, enter the appropriate

IP address.

PORT : Enter the Port Number you assigned the DVR.

ID : Always enter ‘admin’

Password : This must match the password on the DVR. For simplicity, just use numbers.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 51 52

Sin comentarios

Maxtor 4 Channel Stand-alone DVMR Manual de usuario Pagina 41