Maxtor 4-Channel DVR (Digital Video Recorder) Manual de usuario descargar pdf (Pagina 13)

Changing the System Password

1. On the System screen, press ▲ / ▼ to select New Password, then press ENTER.

2. Press ▲ / ▼ to choose a number, then press ◄ / ► to move to the next digit:

3. Press MENU to confirm your change.

4. Press ▲ / ▼ move to another field on the System screen or press MENU to exit this screen and confirm the current

operation.

5. If you have completed all your system configuration changes, press MENU again to exit and close menu setup.

Clearing the Hard Drive Data

This option will erase all data from the hard drive.

Ensure that there are no important recordings on the disk before using this option.

1. On the System screen, press ▲ / ▼ to select Clear HDD, and then press ENTER.

All Data in HDD

Will Be Cleared

Are you sure?

(◄ : No ► : Yes )

2. Press ▲ / ▼ to choose YES to clear the HDD or NO to leave as is.

3. When you choose “Yes” on this option and press ENTER, the DVR will prompt:

4. Press ►to confirm clearing, or ◄ to cancel.

5. Press MENU to confirm your change.

6. Press ▲ / ▼ to move to another field on the System screen or press MENU to exit this

screen and confirm the current operation.

NOTE

: Clearing the data from the Hard Drive results in permanent, irreversible loss of all video and related data currently

stored on the Hard Drive.

Resetting System to Factory Defaults

Using the System Reset option will set all options back to factory default settings. Use the steps below to perform this option.

1. On the System screen, press ▲ / ▼ to select System Reset, and then press ENTER.

2. Press ▲ / ▼ to choose:

Yes = Confirm the system reset and load the default settings.

No = Do not reset the system at this time.

3. Press MENU to exit this screen and confirm the current operation.

4. If you have completed all your system configuration changes, press MENU again to exit and close menu setup.

NOTE

: This will not affect the time and date settings.

Remote Protocol Setup

This feature is used to set the basic RS-232/RS-485 protocols to control the DVR remotely from a PC.

Pressing ENTER after scrolling to the Remote option will bring up the following menu options:

(Menu)

Timer

Record

Alarm

►Remote

System

Event

Remote mode: Selects whether to use an RS-232 or RS-485 interface.

Baud rate:

Selects the baud rate (bps) to be used for the connection.

The available settings are: 115200, 57600, 19200, 9600, 3600, 2400, 1200.

ID:

Selects a numerical number representing the DVR being controlled if multiple

units are being used.

The available setting are: 000 – 255

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 36 37

Comentarios a estos manuales

Sin comentarios

Maxtor 4-Channel DVR (Digital Video Recorder) Manual de usuario Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Grabadores de vídeo digital (dvr) Maxtor 4-Channel DVR (Digital Video Recorder)